Hammer mill operation note

As a result of the intensification of molecular motion of internal parts and the deformation of parts, it is necessary to solve the problem in the following aspects:
First, perform a comprehensive clean-up work onĀ hammer mill, especially grinding rollers, grinding rings, powder collectors, dust removal equipment, and pipelines. Then check the bolts, screws, and other fasteners. Is to help the equipment in a good working condition;
Second, the hammer mill heat operation, for example, put the equipment in a ventilated environment, avoid direct sunlight, if conditions are better, you can add fans and other cooling tools, which can better disperse the surrounding High temperature ensures better work of the equipment;
Third, under hot conditions, more attention should be paid to the daily maintenance and inspection of the equipment. The lubricating oil must be selected so that the ignition point must be high to prevent the occurrence of flammable conditions.
The above describes the situation of hammer mill work in hot weather from three aspects. It pays attention to the cleaning work, heat dissipation work, and the selection of lubricants. These three aspects can effectively ensure the normal operation of the equipment and reduce the production efficiency. The occurrence of the situation.

The purpose of hammer mill

There may be many problems during the hammer mill operation. Therefore, in order to reduce these problems, a trial run operation is required, and possible problems are solved during the test run to ensure that the subsequent production process can be smoothly performed.

In order to reduce the breakdown of hammer mill in the production process, the newly purchased equipment will be commissioned after the installation is completed. This can check the equipment itself and the possible faults in the installation process. This is the purpose of commissioning. Tell us about the correct operation of the test run.

The first is the no-load operation. When the material is not added, run the hammer mill machine, and then observe whether the screws and other parts are loose and whether the wire connection is normal, and the wires need to be protected from being stepped and pressed. Will cause the line problem, but also need to pay attention to whether there is noise or other anomalies, if not, no-load operation takes 2 to 4 hours, so you can fully observe the possible failure, during operation should pay attention to whether the bearing of the hammer mill machine Will be high temperature, etc., these are no problem after the on-load operation.