The Secret of the Lotion Pump Dispenser

I stuck a piece of masking tape on the bottle that said “do not throw away when empty – tell me” so that it wouldn’t get chucked when it ran out. About a week later, I snagged the bottle, cleaned it out thoroughly, and took it upstairs. There, I tried putting the Lotion Pump(KEXON) onto the shampoo bottle, but it didn’t quite fit. So, I simply dumped some of my shampoo/conditioner mix into that bottle, screwed on the lid, and gave it a couple squirts. On the third squirt, a very small amount of shampoo came out. I simply stuck this new bottle into the shower. Next time I took a shower, instead of turning over the squeeze bottle and getting far too much on my hands, I simply reached up and pressed the pump down once, dispensing a perfect amount right on my hand.

Prior to this, my shampoo routine was to buy a large bottle at the warehouse club for about $3 and then use it to refill a smaller container. I did that because using the large jug in the shower meant a ludicrous amount of shampoo would come out each time I wanted to use it – a bad idea. So, with my old bottle, I’d dispense enough shampoo/conditioner for four or so washings with a single squirt. Now, with the new dispenser, a single pump gets almost exactly the right amount for my short hair – just a few drops of it.

Click Foam Pump to learn about more information

Method Of Preservation Of Cosmetics Plastic Pump

Cosmetics Plastic Pump(KEXON) should be placed in a place where normal temperature, dryness and sunlight cannot be directly irradiated, whether in use or unopened; if you want to add a cool feeling to the refrigerator due to summer, you should also stay away from the freezer and return it immediately after use. In the original place, avoid deterioration due to large temperature difference between the inlet and outlet. When not in use, tighten the cap and Plastic Lotion Pumps to maintain a good seal.

Contaminated products such as mascara, which are directly exposed to the eyelashes and stored in the mascara bottle, are preferably replaced three to four months.

In addition to spices and pigments, various high-grade cosmetics include fatty acids, fatty alcohols and petroleum jelly, and are incorporated into proteins, lipid compounds, various amino acids, vitamins, etc.; pharmaceuticals and cosmetics also include royal jelly, white fungus, pearls, ginseng And other organic matter. The above organic substances are not only beneficial to the skin, but also preservatives in cosmetics are sufficient to inhibit or kill harmful microorganisms such as bacteria and molds, and the products are not deteriorated in a short period of time, so that the skin is not damaged. However, if the storage time is too long, the nutrients will be oxidized and decomposed, the role of the preservative will be weakened, and in the past, it will inevitably be polluted by the outside world, so that the microorganisms will multiply in it. If contaminated cosmetics are used, various skin conditions such as local inflammation, acne, and pigmentation may be induced. Therefore, cosmetics that have been stored for more than one year are not suitable for use in principle.

Click Lotion Pump to learn about more information

DIY KEXON Lotion Pump and an Amazing Lotion Recipe

I wanted to share with you for making rhinestone monogrammed Lotion Pump(KEXON) I also wanted to share this recipe for an amazing lotion that has pretty much changed my life the past few months. If you need a gift idea, this combination of lotion with the monogram pump is so easy! So first, let me tell you about this lotion recipe because I have been so excited to share it with you guys!

A friend gave me a jar of this lotion for Valentine’s Day in a mason jar. I kept it by my sink and started using it every day and after a couple days, I looked at my hands and arms and could not believe how smooth and great they looked. I have the worst hands after growing up in the frozen tundra of Minnesota and have always been self conscious in how old they look after years of cold and dry weather. I have tried everything imaginable and nothing has ever helped.

After a couple weeks of using the lotion, my hands and arms began to look like they did in my 20’s (I’m in my 40’s). I know that’s so crazy to say that but the difference has been so incredible for me because they are smooth, very hydrated and so much younger looking. I called my friend Samantha and asked her what the heck she put in that jar!? She texted me the recipe and I could not believe what was in it, just a few inexpensive products;

Click Cream Jar to learn about more information

Foam Pump Bottle Use

As the Foam Pump(KEXON) is used, there is balance aqueous on the screen. If the pump is not acclimated frequently, that soap aqueous can dry, creating a blur on the awning which can ultimately clog the awning authoritative the pump harder to use.

The pump apparatus has a baby bulk of adipose in adjustment to accumulate the pump affective smoothly. While I haven’t been able to get acceptance from the manufacturer, it seems that some soaps eat abroad at the lubricant, abbreviation its capability over time. So far I accept not been able to analyze why the adipose is afflicted by some soaps and not others.

 

If you accept agitation with the pump, decidedly the pump “sticking” and not bustling aback up, analysis the afterward things:

Is the soap too thick? This is a accepted botheration with the pumps. To plan in the cream pump bottles the aqueous should be water-thin. If it is too thick, the pump will not plan appropriately and/or can be assuredly damaged. To resolve, access the concoction amount or use a altered soap.

Is there aqueous in the air chamber? You should see it central the alcove beneath the pump. If so, about-face it upside down and pump a few times which should get the baptize out of the air chamber. If that doesn’t plan (and if you are brave) yield the pump apart, apple-pie it completely, dry thoroughly and reassemble.

 

Click Cream Jar to learn about more information

Measuring Dip Tubes for Lotion Pumps & Treatment Pumps

The neck finish and dip tube length are two essential measurements when matching Lotion Pump(KEXON) and treatment pumps to containers, because the neck finishes must match for a secure fit and the dip tube length must be compatible with the height of the bottle.

Dip tube lengths measure from the gasket to the end of the dip tube and correspond to the measurement of the containers from the shoulders to the base. KEXON has created a cap codes reference document to assist in matching caps to the appropriate bottle. Be sure to match the cap code listed on the desired closure with the appropriate containers. The Addons menu is another excellent feature for matching containers and closures on any product page. Once selected, the Addons drop down menu will display compatible options for pairing and buying all in one place! KEXON highly suggests testing lotion and treatment pumps with the selected containers to ensure compatibility.

Ningbo KeXon Plastic Co., Ltd. is a comprehensive plastic packaging enterprise integrating design, production, and sales. We own a factory (Yuyao KeXon Sprayer Factory), and its plant area is over 6,000 square meters, with more than 20 years of production experience in various types of daily packaging. The company can professionally produce all kinds of foam pumps, plastic caps, daily and medicinal plastic bottles, as well as all kinds of trigger sprayers, lotion pumps, perfume sprayers, cream jar and other products.

Click Plastic Pump to learn about more information

What are the Benefits of a Beauty Trigger Sprayer

This is called steaming machine. The hot steam is scattered and distributed on the cleaned skin. Trigger Sprayer(KEXON) can open the pores, soften your horny and facilitate subsequent maintenance work, such as removing blackheads, exfoliating, and steaming before making masks. It can most effectively absorb the nutrients in the mask, and this hot steam also has a certain whitening effect.

Steamed face machine with cold steam, the effect is better, because after the benefits of hot steaming, after finishing the blackhead, or the horny, after the mask is done, the pores of the skin can be contracted. The pores after maintenance are fine and delicate, and the cold steam has a certain calming and oil control effect~! So this is very useful.

Hey, give you a small suggestion, it is best to add pure water in the home beauty hot and cold spray machine, that is to buy and drink, it is best not to directly add water in the water pipe, because the tap water contains chlorine, There will be precipitation on the skin for a long time.

Ningbo KeXon Plastic Co., Ltd. is a comprehensive plastic packaging enterprise integrating design, production, and sales. We own a factory (Yuyao KeXon Sprayer Factory), and its plant area is over 6,000 square meters, with more than 20 years of production experience in various types of daily packaging. The company can professionally produce all kinds of foam pumps, plastic caps, daily and medicinal plastic bottles, as well as all kinds of trigger sprayers, lotion pumps, perfume sprayers, cream jar and other products.

Click Lotion Pump to learn about more information

Are Lotion Pumps Hard to Find

I’m going to go into this assuming you know foaming soap is a rip off. You know that, right? You pay the same, or more for Foam Pump(KEXON) soap and for that you get – less soap. Here’s how to make your own.

It’s the little things in life that get me all riled up and in a good mood. Remembering I have leftover pizza in the fridge. Watching squirrels scurrying around trying to find hiding places for their nuts in the fall.. Finding out Home Depot now carries the 2″ galvanized pipe elbows with a double sided, screw in end. You know. The little things. Foaming soap is one of those little things. I love it. It’s easy. It comes out puffy and lathery without any work on your part at all. That’s right. I’ll spend 12 hours stacking 2 full, bush cords of wood, but I’m too lazy to lather.

The one thing I don’t like about foaming soap dispensers is refill soap for them is harder to find than regular soap and is usually more expensive. Even though you’re getting less soap. Because 500 ml of regular soap = 500 ml of regular soap. 500 ml of foaming soap is actually only a tiny bit of soap and a bunch of water.

So I figured out how to turn regular liquid hand soap into the sort of soap that will work in a foaming dispenser. Regular liquid hand soap won’t work in a foaming dispenser because it’s too thick. So genius me decided I could probably just add water to it to thin it down. Genius me was right. Getting the proportions right isn’t even difficult. It’s pretty forgiving. It’s foaming soap, not an atomic bomb.

Click Foam Pump Manufacturers to learn about more information